Hakko Electronics Monitouch V9 Series Connection Manual page 369

18-4 18. GE Fanuc
IC693CMM311
Configuration Mode
CCM Enable
CCM Mode
Interface
Date Rate
Flow Control
Port 1
Parity
Retry Count
Timeout
Turnaround Delay
CCM CPU ID
CCM Enable
CCM Mode
Interface
Date Rate
Flow Control
Port 2
Parity
Retry Count
Timeout
Turnaround Delay
CCM CPU ID
Calendar
This model is not equipped with the calendar function. Use the built-in clock of the V series.
Available Device Memory
The available setting range of device memory varies depending on the PLC model. Be sure to set within the range available for
the PLC to be used. Use [TYPE] when assigning indirect device memory for macro programs.
R (register)
I (input)
Q (output)
Indirect Device Memory Designation
For the device memory address number, specify the value obtained by subtracting "1" from the actual address.
Item
CCM ONLY, CCM/RTU, RTU/CCM,
LONG / MEDIUM / SHORT / NONE
NONE / 10 ms / 100 ms / 500 ms
LONG / MEDIUM / SHORT / NONE
NONE / 10 ms / 100 ms / 500 ms
Device Memory
Setting
SNP/CCM, CCM/SNP
YES
SLAVE
RS-232
4800 / 9600 / 19200 bps
NONE
NONE / ODD
NORMAL / SHORT
1 to 31
YES
SLAVE
RS-232 / RS-485
4800 / 9600 / 19200 bps
NONE
NONE / ODD
NORMAL / SHORT
1 to 31
TYPE
00H
01H
02H
(Underlined setting: default)
Remarks
Remarks