Series (Snp-X) - Hakko Electronics Monitouch V9 Series Connection Manual

18.1.2 90 Series (SNP-X)

Communication Setting
Editor
Communication setting
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
PLC
Be sure to match the settings to those made under [Communication Setting] of the editor.
90 series (SNP-X)
Baud Rate
Parity
Transmission code
Function
Calendar
This model is not equipped with the calendar function. Use the built-in clock of the V series.
Available Device Memory
The available setting range of device memory varies depending on the PLC model. Be sure to set within the range available for
the PLC to be used. Use [TYPE] when assigning indirect device memory for macro programs.
R (register)
I (input)
Q (output)
M (internal relay)
G (global relay)
AI (analog input)
AQ (analog output)
T (temporary memory relay)
S (system status)
SA (system status)
SB (system status)
SC (system status)
Indirect Device Memory Designation
For the device memory address number, specify the value obtained by subtracting "1" from the actual address.
Item
1 : 1 / Multi-link2 / Multi-link2 (Ethernet)
Item
Data Length
Stop Bit
Device Memory
Setting
RS-232C / RS-422/485
4800 / 9600 / 19200 bps
8 bits
1 / 2 bits
None / Odd / Even
Setting
19200 bps
Odd
8 bits
1 bit
SNP-X
TYPE
00H
01H
02H
03H
04H
05H
06H
07H
08H Read only
09H
0AH
0BH
18.1 PLC Connection
(Underlined setting: default)
Remarks
Remarks
Remarks
18-5