Hakko Electronics Monitouch V9 Series Connection Manual page 185

7.1.5 LT400 Series (MODBUS RTU)
Communication Setting
Editor
Communication setting
Item
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
Digital Indicating Controller
The communication parameters can be set using keys attached to the digital indicating controller.
Be sure to match the settings to those made under [Communication Setting] of the editor.
Mode
Mode 1
eng (engineering)
Mode 7
commu (communication
setting)
* When changing parameters from the V series, set "LoCK (key lock): 4".
Available Device Memory
The available setting range of device memory varies depending on the model. Be sure to set within the range available for the
model to be used. Use [TYPE] when assigning indirect device memory for macro programs.
Device Memory
4 (analog setting value)
3 (analog input data)
0 (digital setting value)
1 (digital input data)
Indirect Device Memory Designation
For the device memory address number, specify the value obtained by subtracting "1" from the actual address.
7.1 Temperature Controller/Servo/Inverter Connection
Setting
1 : 1 / 1 : n / Multi-link2 /
Multi-link2 (Ethernet) /
1 : n Multi-link2 (Ethernet)
RS-232C / RS-422/485
9600 / 19200 bps
8 bits
1 / 2 bits
None / Odd / Even
1 to 99
Display Item
LoCK Key lock
PrtCL Communication protocol
FUnC Communication function
AdrS Device No.
rAtE Baud rate
Character
CHArA (Data length, parity, stop
bit)
TYPE
00H
01H Read only
02H
03H Read only
Remarks
Setting
*
4: All items prohibited
rtU: MODBUS (RTU)
Com: Host communication
01 to 99
9600 / 19200 bps
8N1: 8 bits / without parity / 1 bit
8N2: 8 bits / without parity / 2 bits
8E1: 8 bits / even parity / 1 bit
8E2: 8 bits / even parity / 2 bits
8O1: 8 bits / odd parity / 1 bit
8O2: 8 bits / odd parity / 2 bits
Remarks
7-11
(Underlined setting: default)
(Underlined setting: default)