Hakko Electronics Monitouch V9 Series Connection Manual page 403

20-8 20. Hitachi Industrial Equipment Systems
20.1.2 HIDIC-H (Ethernet)
Communication Setting
Editor
Make the following settings on the editor. For more information, see "1.3.2 Ethernet Communication".
 IP address for the V9 unit
- When specified on the screen program:
[System Setting]  [Hardware Setting]  [Local Port IP Address]
- When specified on the V9 unit:
Local mode  [LAN Setting]
 Port number for the V9 unit (for communication with PLC)
[System Setting]  [Hardware Setting]  [PLC Properties]  [Communication Setting]
 IP address and port number of the PLC
Register on the [PLC Table] in [System Setting]  [Hardware Setting]  [PLC Properties]  [Target Settings].
LAN-ETH2 (H Series)
The IP address setting tool can be downloaded from the Hitachi Industrial Equipment Systems website.
Connect the computer (PC) to the RS-232C port of PORT1 and specify the IP address and the task port. For more information,
refer to the PLC manual issued by the manufacturer.
EH-ETH (EH-150)
Make settings using the web server function incorporated in EH-ETH. For more information, refer to the PLC manual issued by
the manufacturer.
IP address information setup
Set the IP address and the subnet mask.
Task code information setup
Select [UDP/IP] for [Protocol] and specify the port number.
Web Controller
Connect the computer (PC) to the web controller and make the setting for the PLC with the web browser. For more
information, refer to the PLC manual issued by the manufacturer.
System configuration (IP address)
Specify the IP address and the subnet mask.
System configuration (ethernet protocol  passive HI protocol)
Select [UDP/IP] for [Task code port] and specify the port number.