Series (Snp) - Hakko Electronics Monitouch V9 Series Connection Manual

18-6 18. GE Fanuc

18.1.3 90 Series (SNP)

Communication Setting
Editor
Communication setting
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
PLC
Be sure to match the settings to those made under [Communication Setting] of the editor.
IC693CMM311 / IC697CMM711
Configuration Mode
SNP Enable
SNP Mode
Interface
Date Rate
Port 1 Flow Control
Parity
Stop Bits
Timeout
Modem Turnaround Delay
SNP Enable
SNP Mode
Interface
Date Rate
Port 2 Flow Control
Parity
Stop Bits
Timeout
Modem Turnaround Delay
90-30 Series / 90-70 Series
Parameter
Port Mode
Data Rate
Parity
Stop Bits
Physical Interface
Item
1 : 1 / Multi-link2 / Multi-link2 (Ethernet)
4800 / 9600 / 19200 / 38400 / 57600 / 115K bps
Item
SNP ONLY, SNP/CCM, CCM/SNP, SNP/RTU,
Setting
RS-232C / RS-422/485
8 bits
1 / 2 bits
None / Odd / Even
Setting
RTU/SNP
YES
SLAVE
RS485 / RS232
4800 / 9600 / 19200 bps
NONE
ODD / EVEN / NONE
1 / 2
LONG / MEDIUM / SHORT / NONE
NONE/ 10 ms / 100 ms / 500 ms
YES
SLAVE
RS485 / RS232
4800 / 9600 / 19200 bps
NONE
ODD / EVEN / NONE
1 / 2
LONG / MEDIUM / SHORT / NONE
NONE/ 10 ms / 100 ms / 500 ms
Setting
SNP Slave
4800 / 9600 / 19200 bps
ODD / EVEN / NONE
1 / 2
2-wire / 4-wire
(Underlined setting: default)
Remarks
(Underlined setting: default)
Remarks
Only RS232C supported by IC693CMM311
(Underlined setting: default)
Remarks
Both valid for RS232