Nx (Cpl) - Hakko Electronics Monitouch V9 Series Connection Manual

4.2.13 NX (CPL)

Communication Setting
Editor
Communication setting
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
Controller
Make the following settings on [Actual Module Configuration] in the [SLP-NX] software.
RS-485 Address
RS-485 Protocol
RS-485 Baud Rate
RS-485 Bit Length
RS-485 Parity Setting
RS-485 Stop Bit
Available Device Memory
The available setting range of device memory varies depending on the model. Be sure to set within the range available for the
model to be used. Use [TYPE] when assigning indirect device memory for macro programs.
Device Memory
Item
1 : 1 / 1 : n / Multi-link2 / Multi-link2 (Ethernet) /
4800 / 9600 / 19200 / 38400 / 57600 / 115K bps
Item
4800 / 9600 / 19200 / 38400 / 57600 / 115200
TYPE
--- 00H
4.2 Temperature Controller/Servo/Inverter Connection
Setting
1 : n Multi-link2 (Ethernet)
RS-232C / RS-422/485
7 / 8 bits
1 / 2 bits
None / Odd / Even
1 to 127
Setting
1 to 127
CPL
bps
7 / 8 bits
None / Odd / Even
1 / 2 bits
(Underlined setting: default)
Remarks
(Underlined setting: default)
Remarks
Communication is disabled when "0" is set.
Remarks
4-25