Faldic-W Series - Hakko Electronics Monitouch V9 Series Connection Manual

16.2.24 FALDIC-W Series

Communication Setting
Editor
Communication setting
Item
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
* When changing the time-out time, note the following points. (Default: 500 (msec))
- When the baud rate is 19200 bps or 38400 bps, set 200 (msec) or greater.
- When the baud rate is 9600 bps, set 500 (msec) or greater.
Servo Amplifier
Set the communication parameters using the touch panel mounted on the servo amplifier.
Be sure to match the settings to those made under [Communication Setting] of the editor.
Parameter
editing mode
* The following communication parameters are fixed; data length: 8 bits, stop bit: 1 bit, and parity: even.
Available Device Memory
The available setting range of device memory varies depending on the model. Be sure to set within the range available for the
model to be used. Use [TYPE] when assigning indirect device memory for macro programs.
Device Memory
01 (monitor data)
02 (sequence mode)
03 (sequence I/O signal)
04 (alarm history)
06 (current alarm readout)
07 (parameter)
09 (alarm reset)
Setting
1 : 1 / 1 : n / Multi-link2 /
Multi-link2 (Ethernet) /
1 : n Multi-link2 (Ethernet)
RS-422/485
9600 / 19200 / 38400 bps
8 bits
1 to 31
Parameter
(No. 82) Station number
(No. 83) Baud rate
TYPE
00H
01H
02H
03H
04H
05H
06H
16.2 Temperature Controller/Servo/Inverter Connection
Do not change the default setting other than baud rate because
the setting on the servo amplifier cannot be changed.
1 bit
Even
Item Setting
1 to 31
0: 38400 bps
1: 19200 bps
2: 9600 bps
Double-word, read only
Read only
Read only
Read only
Read only
Double-word
Write only
(Underlined setting: default)
Remarks
(Underlined setting: default)
Example Remarks
1
The setting takes effect
when the power is turned
off and back on again.
0
Remarks
16-71