We1Ma (Ver. A) (Modbus Rtu) - Hakko Electronics Monitouch V9 Series Connection Manual

16.2.31 WE1MA (Ver. A) (MODBUS RTU)

Communication Setting
Editor
Communication setting
Item
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
Electronic Multimeter
The communication parameter can be set using keys attached to the front of the electronic multimeter.
Be sure to match the settings to those made under [Communication Setting] of the editor.
Setting
Component
Adr
bPS
PAr
StoP
WEr
* The communication parameter (data length) is fixed to 8 bits.
Available Device Memory
The available setting range of device memory varies depending on the model. Be sure to set within the range available for the
model to be used. Use [TYPE] when assigning indirect device memory for macro programs.
Device Memory
1 (input relay)
4 (holding register)
3 (input register)
1 : 1/1 : n / Multi-link2 /
Multi-link2 (Ethernet) /
1 : n Multi-link2 (Ethernet)
RS-422/485
4800 / 9600 / 19200 / 38400 bps
1 / 2 bits
None / Even / Odd
0 to 247
Setting No. Item
231C Station address
232C Baud rate
233C Parity bit
234C Stop bit
235C Protocol version
16.2 Temperature Controller/Servo/Inverter Connection
Setting
8 bits
0: Broadcast
1 to 247
4800 / 9600 / 19200 / 38400 bps
E: Even
o: Odd
-: None
1 / 2 bits
A: Version A
TYPE
01H Read only
02H
03H Read only
(Underlined setting: default)
Remarks
(Underlined setting: default)
Setting
Remarks
16-89
Example
1
9600
E
1
A