Hakko Electronics Monitouch V9 Series Connection Manual page 216

10.1.2 PMAC (Ethernet TCP/IP)
Communication Setting
Editor
Make the following settings on the editor. For more information, see "1.3.2 Ethernet Communication".
 IP address for the V9 unit
- When specified on the screen program:
[System Setting]  [Hardware Setting]  [Local Port IP Address]
- When specified on the V9 unit:
Local mode  [LAN Setting]
 Port number for the V9 unit (for communication with PLC)
[System Setting]  [Hardware Setting]  [PLC Properties]  [Communication Setting]
 IP address and port number of the PLC
Register on the [PLC Table] in [System Setting]  [Hardware Setting]  [PLC Properties]  [Target Settings].
10.1 Temperature Controller/Servo/Inverter Connection
Valid only for 1 : 1 connection
Select the PLC for connection from those
registered on the PLC table.
10-5
Set the IP address, port number
1025 and whether or not to use
the KeepAlive function of the PLC.