1 : 1 / 1 : N / Multi-Link2 / Multi-Link2 (Ethernet); Pyx (Modbus Rtu) - Hakko Electronics Monitouch V9 Series Connection Manual

16.2.1 PYX (MODBUS RTU)

Communication Setting
Editor
Communication setting
Item
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
Temperature Controller
The communication parameter can be set using keys attached to the front of the temperature controller.
Be sure to match the settings to those made under [Communication Setting] of the editor.
Parameter
* The communication function of the temperature controller can be selected from Fuji protocol or Modbus protocol at the time of purchase.
For communication with a V9, select a model on which the Modbus protocol is available.
* The following communication parameters are fixed; baud rate: 9600 bps, data length: 8 bits, stop bit: 1 bit, and parity: odd.
Available Device Memory
The available setting range of device memory varies depending on the model. Be sure to set within the range available for the
model to be used. Use [TYPE] when assigning indirect device memory for macro programs.
Device Memory
0
1
4
3
16.2 Temperature Controller/Servo/Inverter Connection
Setting
1 : 1 / 1 : n / Multi-link2 /
Multi-link2 (Ethernet) /
1 : n Multi-link2 (Ethernet)
RS-422/485
9600 bps
8 bits
1 bit
Odd
1 to 31
Item
Digital transmission function
(station number)
TYPE
00H
01H Read only
02H
03H Read only
Remarks
Do not change the default settings because these settings on the
temperature controller cannot be changed.
Setting
1 to 31
Remarks
16-25
(Underlined setting: default)
(Underlined setting: default)
Example
1