Hakko Electronics Monitouch V9 Series Connection Manual page 289

16-36 16. Fuji Electric
F-MPC04S
Communication setting
The communication parameters can be set using keys attached to the front of the power monitor unit.
Be sure to match the settings to those made under [Communication Setting] of the editor.
Setting Code
L-
L2-
LA-
Lt-
*1 The communication function of F-MPC04 can be selected at the time of purchase. Select a model on which "F-MPC04 mode" is available.
*2 The communication parameter (stop bit) is fixed to 1 bit.
F-MPC30
Communication setting
The communication parameters can be set using keys attached to the front of the power monitor unit.
Be sure to match the settings to those made under [Communication Setting] of the editor.
Setting Code
90
91
* The communication parameter (stop bit) is fixed to 1 bit.
Item
Baud rate
Data length and parity
Address
(Transmission station number)
Communication model mode
Item
RS-485 address setting
RS-485 transmission specification
Setting
4.8: 4800 bps
9.6: 9600 bps
19.2: 19200 bps
8n: Data length 8 bits, without parity
8E: Data length 8 bits, even parity
8o: Data length 8 bits, odd parity
7n: Data length 7 bits, without parity
7E: Data length 7 bits, even parity
7o: Data length 7 bits, odd parity
Loc: Station number not set
01 to 99
*1
04: F-MPC04 mode
PP: PPM (B) mode
Setting
Loc: Communication not used
01 to 99
7SEG LED
Data length
Baud rate
48: 4800 bps
96: 9600 bps
192: 19200 bps
* "b192E" is set as default.
(Underlined setting: default)
(Underlined setting: default)
Parity
n: None
E: Even
o: Odd
7: 7 bits
8: 8 bits
Example
19.2
7o
01
04
Example
01
1927o