Hakko Electronics Monitouch V9 Series Connection Manual page 184

7-10 7. CHINO
7.1.4 LT300 (MODBUS RTU)
Communication Setting
Editor
Communication setting
Item
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
Digital Indicating Controller
The communication parameters can be set using keys attached to the digital indicating controller.
Be sure to match the settings to those made under [Communication Setting] of the editor.
Mode
Mode 1
eng (engineering)
Mode 7
com (communication setting)
* When changing parameters from the V series, set "LoCK (key lock): 4".
Available Device Memory
The available setting range of device memory varies depending on the model. Be sure to set within the range available for the
model to be used. Use [TYPE] when assigning indirect device memory for macro programs.
Device Memory
4 (analog setting value)
3 (analog input data)
0 (digital setting value)
1 (digital input data)
Indirect Device Memory Designation
For the device memory address number, specify the value obtained by subtracting "1" from the actual address.
Setting
1 : 1 / 1 : n / Multi-link2 / Multi-link2 (Ethernet) /
1 : n Multi-link2 (Ethernet)
RS-232C / RS-422/485
9600 / 19200 bps
8 bits
1 / 2 bits
None / Odd / Even
1 to 99
Indication Item
LoCK Key lock
PtCL Communication protocol
FUnC Communication function
AdrS Device No.
rAtE Baud rate
Character
CHAr (Data length, parity,
stop bit)
TYPE
00H
01H Read only
02H
03H Read only
Remarks
Setting
*
4: All items prohibited
rtU: MODBUS (RTU)
Com: Host communication
01 to 99
9600 / 19200 bps
5: 8 bits / without parity / 1 bit
6: 8 bits / without parity / 2 bits
7: 8 bits / even parity / 1 bit
8: 8 bits / even parity / 2 bits
9: 8 bits / odd parity / 1 bit
10: 8 bits / odd parity / 2 bits
Remarks
(Underlined setting: default)
(Underlined setting: default)