Hakko Electronics Monitouch V9 Series Connection Manual page 259

16-6 16. Fuji Electric
Available Device Memory
The available setting range of device memory varies depending on the PLC model. Be sure to set within the range available for
the PLC to be used. Use [TYPE] when assigning indirect device memory for macro programs.
M (auxiliary relay)
K (keep relay)
B (input/output relay)
L (link relay)
F (special relay)
TS (timer/set value)
TR (timer/current value)
W9 (0.1-sec timer/current value)
CS (counter/set value)
CR (counter/current value)
BD (data memory)
WS (step relay)
Wn (file memory)
*1 For items where double-words can be used (Num. Display, Graph, Sampling), data is processed as double-words.
For those where bits or words can be used, data is processed as words consisting of lower 16 bits.
For input:
For output: "0" is written for upper 16 bits.
*2 WS (step relay) is a byte device processed as described below.
For input:
For output: Lower 8 bits are written.
*3 To set up the file memory on the editor, enter "file number" + ": (colon)" + "address" in
order.
*4 Define the file area as "SI".
Device Memory
Upper 16 bits are ignored.
Upper 8 bits are "0".
TYPE
00H WM as word device
01H WK as word device
02H WB as word device
09H WL as word device
0AH WF as word device
0BH *1
0CH *1
0DH *1
0EH *1
0FH *1
10H *1
11H *2
12H *3, *4
Example: W30 : 00002
Remarks
Address
Colon
File number