Hakko Electronics Monitouch V9 Series Connection Manual page 152

4.2.11 AHC2001+DCP31/32
Communication Setting
Editor
Communication setting
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
Controller
AHC2001 SCU unit setting
Parameter
Group ID
Type ID
*1
002
Exx
*1 xx: Unit position 01 to 10H
The unit position varies depending on the mounting position of the SCU unit.
Power
supply
DCP31/32
Setting group: Make the following setting on the setup data.
Item
Communication
address
Baud rate
Data type
Item
1 : 1 / 1 : n / Multi-link2 / Multi-link2 (Ethernet) /
Item ID
01 Baud rate
02 Data bit length
03 Parity
04 Stop bit
05 Half duplex / full duplex
07 Protocol selection
CPU SCU SCU
E01h E02h
Indication
C84 1 to 31
0: 9600 bps, even parity, 1 stop bit
1: 9600 bps, without parity, 2 stop bit
C85
2: 4800 bps, even parity, 1 stop bit
3: 4800 bps, without parity, 2 stop bit
C93 0: Additional terminal
4.2 Temperature Controller/Servo/Inverter Connection
Setting
1 : n Multi-link2 (Ethernet)
RS-232C / RS-422/485
9600 / 19200 / 38400 bps
7/ 8 bits
1 / 2 bits
None / Odd / Even
1 to 31
Setting Items
9600 bps
19200 bps
38400 bps
7: 7 bits
8: 8 bits
0: None
1: Even
2: Odd
1: 1 bit
2: 2 bits
0: Half duplex
1: Full duplex
2: CPL server
Setting
(Underlined setting: default)
Remarks
(Underlined setting: default)
Contents
Half duplex: 2-wire connection
Full duplex: 4-wire connection
 Unit position E01H - E10H
E10h
(Underlined setting: default)
Remarks
Communication is disabled when "0" is set.
4-21
Remarks