Hakko Electronics Monitouch V9 Series Connection Manual page 218

5. The [ETHUSBConfigure] dialog is displayed.
Click [OK].
6. The [Ethernet Configuration] dialog is displayed again.
Click [Done] in the dialog.
7. Turn the power off and back on again.
* UMAC settings must be made via USB communication.
Before performing Ethernet communication with MONITOUCH, turn the power to UMAC off and remove the USB cable. Then, insert the
Ethernet cable and turn the power on again.
I-Variables by number
Address
I3
I6 Error notification mode
I63 <Control-X> Echo valid/invalid
* Values after change are saved in FROM and determined when the power is turned off and back on again.
UMAC Turbo CPU
TURBO CPU BOARD E-POINT
E-POINT
2
E6
1
10.1 Temperature Controller/Servo/Inverter Connection
Contents
Handshake I/O control
Contents
Reloading the micro controller firmware
2
1
1: Valid
Normal operation: Install a jumper between pins
1 and 2.
Setting
Setting
10-7