Hakko Electronics Monitouch V9 Series Connection Manual page 140

4.2.2 SDC20
Communication Setting
Editor
Communication setting
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
Controller
Make the following settings.
Item
Communication
address
Baud rate
Data type
Available Device Memory
The available setting range of device memory varies depending on the model. Be sure to set within the range available for the
model to be used. Use [TYPE] when assigning indirect device memory for macro programs.
Device Memory
* The number of times EEPROM can be reprogrammed is limited (approx. 100,000 times). Accordingly, we recommend that
you write such a parameter as to be reprogrammed frequently into RAM, where the number of reprogramming times is
not limited. However, when the parameter has been written into RAM, and the power is turned off and back on again,
data in EEPROM is transferred.
For more information, refer to the instruction manual for the controller issued by the manufacturer.
4.2.3 SDC21
Settings are the same as those described in "4.2.2 SDC20".
Item
1 : 1 / 1 : n / Multi-link2 / Multi-link2 (Ethernet) /
Indication
C31 1 to 31
0: 9600 bps
C32
1: 4800 bps
0: 8 bits, 1 stop bit, even parity
C33
1: 8 bits, 2 stop bit, without parity
TYPE
--- 00H
4.2 Temperature Controller/Servo/Inverter Connection
Setting
1 : n Multi-link2 (Ethernet)
RS-232C / RS-422/485
4800 / 9600 bps
8 bits
1 / 2 bits
None / Odd / Even
1 to 31
Setting
Without "*": RAM
With "*": RAM + EEPROM
(Underlined setting: default)
Remarks
(Underlined setting: default)
Remarks
Communication is disabled when "0" is set.
Remarks
4-9