Hakko Electronics Monitouch V9 Series Connection Manual page 198

8.1.2 CP Series
Communication Setting
Editor
Communication setting
Item
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
PLC
LOADER Port
No particular setting is necessary on the PLC.
The communication parameters are fixed; signal level: RS-232C, baud rate: 38400 bps, data length: 8 bits, stop bit: 1 bit, parity:
none.
CM1-CP4C/CM1-CP4D
Make communication settings using the application software "CICON". For more information, refer to the instruction manual
issued by CIMON.
Item
Type
Baud Rate
Parity
Data Bit
Stop Bit
Setting
1 : 1 / Multi-link2 / Multi-link2 (Ethernet)
RS-232C / RS-422/485
9600 / 19200 / 38400 bps
7 / 8 bits
1 / 2 bits
None / Odd / Even
Setting
Null / RS-422, Modem / RS-485
9600 / 19200 / 38400 bps
Even / Odd / None
7 / 8 bits
1 / 2 bits
8.1 PLC Connection
(Underlined setting: default)
Remarks
Remarks
RS-232C connection: Null / RS-422
RS-422 (4-wire) connection:
Null / RS-422
RS-485 (2-wire) connection:
Modem / RS-485
8-5