Series (Ethernet Tcp/Ip) - Hakko Electronics Monitouch V9 Series Connection Manual

18-8 18. GE Fanuc

18.1.4 90 Series (Ethernet TCP/IP)

Communication Setting
Editor
Make the following settings on the editor. For more information, see "1.3.2 Ethernet Communication".
 IP address for the V9 unit
- When specified on the screen program:
[System Setting]  [Hardware Setting]  [Local Port IP Address]
- When specified on the V9 unit:
Local mode  [LAN Setting]
 Port number for the V9 unit (for communication with PLC)
[System Setting]  [Hardware Setting]  [PLC Properties]  [Communication Setting]
 IP address and port number (No. 18245) of the PLC
Register on the [PLC Table] in [System Setting]  [Hardware Setting]  [PLC Properties]  [Target Settings].
PLC
Parameters
IP Address
Subnet Mask
Gateway IP Address
Calendar
This model is not equipped with the calendar function. Use the built-in clock of the V series.
Available Device Memory
The available setting range of device memory varies depending on the PLC model. Be sure to set within the range available for
the PLC to be used. Use [TYPE] when assigning indirect device memory for macro programs.
R (register)
I (input)
Q (output)
M (internal relay)
G (global relay)
AI (analog input)
AQ (analog output)
T (temporary memory relay)
S (system status)
SA (system status)
SB (system status)
SC (system status)
Indirect Device Memory Designation
For the device memory address number, specify the value obtained by subtracting "1" from the actual address.
Item
Make settings in accordance with the network
Device Memory
Setting
Set the IP address of the PLC.
Set the subnet mask of the PLC.
environment.
TYPE
00H
01H
02H
03H
04H
05H
06H
07H
08H Read only
09H
0AH
0BH
Remarks
Remarks