Hakko Electronics Monitouch V9 Series Connection Manual page 127

PORT3
Set parameters into the special register "R776, 777", then set "5AAA" (HEX) into the setting complete register "R767". When
the set value at R767 is changed to "AAAA" (HEX), it is regarded as normal; if it is changed to "EAAA" (HEX), it is regarded as
erroneous.
Parameter setting register
Register
R776 Same as the setting register R772 for PORT1
R777 Same as the setting register R773 for PORT1
D2-250-1
PORT2
Set parameters into the special register "R7655, 7656", then set "0500" (HEX) into the setting complete register "R7657". When
the set value at R7657 is changed to "0A00" (HEX), it is regarded as normal; if it is changed to "0E00" (HEX), it is regarded as
erroneous.
Parameter setting register
Register
R7655
R7656
Available Device Memory
The available setting range of device memory varies depending on the PLC model. Be sure to set within the range available for
the PLC to be used. Use [TYPE] when assigning indirect device memory for macro programs.
V (data register)
X (input)
Y (output)
C (internal relay)
S (stage)
GX (transmission relay for all stations)
GY (transmission relay for specified station)
T (timer/contact)
CT (counter/contact)
0 0 2 0
Communication protocol
20: MODBUS RTU
Communication timeout
0: Specified time
Response delay time
0: 0 ms
8 7 0 1
Station number
01 to 7A (HEX)
Baud rate
4: 4800 bps
5: 9600 bps
6: 19200 bps
7: 38400 bps
Parity stop bit
0: Without parity, stop bit 1
2: Without parity, stop bit 2
8: Odd parity, stop bit 1
A: Odd parity, stop bit 2
C: Even parity, stop bit 1
E: Even parity, stop bit 2
Device Memory
Setting
Setting
TYPE
00H
01H
02H
03H
04H
05H
06H
07H
08H
3.1 PLC Connection
Setting Example
00E0H
8701H
(Underlined setting: default)
Setting Example
0020H
8701H
38400 bps
Odd parity
Stop bit 1
Station number 01
Remarks
3-7