Hakko Electronics Monitouch V9 Series Connection Manual page 182

7-8 7. CHINO
7.1.2 DB1000B (MODBUS RTU)
Communication Setting
Editor
Communication setting
Item
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
Digital Indicating Controller
The communication parameters can be set using keys attached to the digital indicating controller.
Be sure to match the settings to those made under [Communication Setting] of the editor.
Mode No.
Mode 7
(Communication
setting)
Notes on parameter change from the V series
Before changing parameters from the V series, all modes on the setting screen must be locked using keys on the digital
indicating controller. For more information, refer to the instruction manual for the controller issued by the
manufacturer.
Available Device Memory
The available setting range of device memory varies depending on the model. Be sure to set within the range available for the
model to be used. Use [TYPE] when assigning indirect device memory for macro programs.
Device Memory
4 (analog setting value)
3 (analog input data)
0 (digital setting value)
1 (digital input data)
Indirect Device Memory Designation
For the device memory address number, specify the value obtained by subtracting "1" from the actual address.
1 : 1 / 1 : n / Multi-link2 / Multi-link2 (Ethernet) /
1 : n Multi-link2 (Ethernet)
RS-232C / RS-422/485
4800 / 9600 / 19200 / 38400 bps
None / Odd / Even
Item
Baud rate 4800 / 9600 / 19200 / 38400 bps
Device No. 01 to 99
Communication function COM: Host communication
Communication protocol MODBUS (RTU)
8 bits / without parity / 1 bit
8 bits / without parity / 2 bits
Communication characters
8 bits / even parity / 1 bit
(Data length, parity,
8 bits / even parity / 2 bits
stop bit)
8 bits / odd parity / 1 bit
8 bits / odd parity / 2 bits
TYPE
00H
01H
02H
03H
Setting
8 bits
1 / 2 bits
1 to 99
Setting
Read only
Read only
(Underlined setting: default)
Remarks
(Underlined setting: default)
Remarks
Remarks