Wsz Series - Hakko Electronics Monitouch V9 Series Connection Manual

16.2.33 WSZ Series

Communication Setting
Editor
Communication setting
Item
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
WSZ Series
Make settings for the controller by using the software "WinProladder". For more information, refer to the instruction manual
of the controller issued by the manufacturer.
Station Number
Setting Items
Station Number
PORT 0
Comm. Parameters Setting - Port 0
Setting Items
Baud Rate
* The following settings are fixed; data length: 7, stop bit: 1, parity: even, and protocol: Fatek Communication protocol.
WSZ-CB25 (PORT 1 / PORT 2)
Comm. Parameters Setting - Port 1 / Port 2
Setting Items
Baud Rate
Parity
Data Bit
Stop Bit
Protocol
DIPSW
Setting Items
Terminating resistance
T
Setting
1 : 1 / 1 : n / Multi-link2 /
Multi-link2 (Ethernet) /
1 : n Multi-link2 (Ethernet)
RS-232C / RS-422/485
4800 / 9600 / 19200 / 38400 / 57600 /
76800 / 115k bps
7 / 8 bits
1 / 2 bits
None / Even / Odd
1 to 254
1 to 254
9600 / 19200 / 38400 / 57600 / 115200
4800 / 9600 / 19200 / 38400 / 57600 / 76800 / 115200
None / Even / Odd
7 / 8
1 / 2
Fatek Communication protocol
ON: With terminating resistance
OFF: Without terminating resistance
N
16.2 Temperature Controller/Servo/Inverter Connection
Setting
Setting
Setting
Setting
(Underlined setting: default)
Remarks
(Underlined setting: default)
Remarks
(Underlined setting: default)
Remarks
The baud rate can also be set by
specifying a value for the designated
address.
For more information, refer to the
instruction manual of the controller issued
by the manufacturer.
(Underlined setting: default)
Remarks
The baud rate can also be set by
specifying a value for the designated
address.
For more information, refer to the
instruction manual of the controller issued
by the manufacturer.
Remarks
This setting must be the same for both
switches.
16-91