Hakko Electronics Monitouch V9 Series Connection Manual page 368

18.1.1 90 Series
Communication Setting
Editor
Communication setting
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
PLC
Be sure to match the settings to those made under [Communication Setting] of the editor.
PCM
Configuration Mode
CCM Enable
CCM Mode
Interface
Date Rate
Flow Control
Port 1
Parity
Retry Count
Timeout
Turnaround Delay
CPU ID
CCM Enable
CCM Mode
Interface
Date Rate
Flow Control
Port 2
Parity
Retry Count
Timeout
Turnaround Delay
CPU ID
Calendar
This model is not equipped with the calendar function. Use the built-in clock of the V series.
Item
1 : 1 / 1 : n / Multi-link2 / Multi-link2 (Ethernet) /
Item
CCM ONLY, BAS/CCM, PROG/CCM, CCM/PROG
LONG / MEDIUM / SHORT / NONE
NONE / 10 ms / 100 ms / 500 ms
LONG / MEDIUM / SHORT / NONE
NONE / 10 ms / 100 ms / 500 ms
Setting
1 : n Multi-link2 (Ethernet)
RS-232C / RS-422/485
4800 / 9600 / 19200 bps
8 bits
1 bit
None / Odd
1 to 31
Setting
YES
SLAVE
RS-232
4800 / 9600 / 19200 bps
NONE
NONE / ODD
NORMAL / SHORT
1 to 31
YES
SLAVE
RS-232 / RS-485
4800 / 9600 / 19200 bps
NONE
NONE / ODD
NORMAL / SHORT
1 to 31
18.1 PLC Connection
(Underlined setting: default)
Remarks
(Underlined setting: default)
Remarks
Only RS-485 is available with IC693PCM300.
18-3