F-Mpc04P (Loader) - Hakko Electronics Monitouch V9 Series Connection Manual

16.2.6 F-MPC04P (Loader)

Communication Setting
Editor
Communication setting
Item
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
*1 To use port No. 32 to 99, use the station number table.
Power Monitor Unit
Be sure to match the settings to those made under [Communication Setting] of the editor.
Station number setting
Station
ADDRESS SW
0
Communication setting
The communication parameter can be set using keys attached to the front of the power monitor unit.
Circuit No.
C
* The communication parameter (stop bit) is fixed to 1 bit.
Available Device Memory
The available setting range of device memory varies depending on the model. Be sure to set within the range available for the
model to be used. Use [TYPE] when assigning indirect device memory for macro programs.
Device Memory
Setting
1 : 1 / 1 : n / Multi-link2 /
Multi-link2 (Ethernet) /
1 : n Multi-link2 (Ethernet)
RS-422/485
4800 / 9600 / 19200 bps
7 / 8 bits
1 bit
None / Odd / Even
1 to 99
Setting
01 to 99 [DEC] (default: 0)
0
Setting Code
Baud rate
L1-
Parity
L2-
Data length
L3-
TYPE
--- 00H
16.2 Temperature Controller/Servo/Inverter Connection
Do not change the default setting because the setting on the
power monitor unit cannot be changed.
*1
Example
1
Item
00: 4800 bps
01: 9600 bps
02: 19200 bps
00: None
01: Even
02: Odd
00: 7 bits
01: 8 bits
Double-word
(Underlined setting: default)
Remarks
Remarks
(Underlined setting: default)
Setting
Remarks
16-31
Example
02
02
00