Hakko Electronics Monitouch V9 Series Connection Manual page 249

Available Device Memory
The available setting range of device memory varies depending on the PLC model. Be sure to set within the range available for
the PLC to be used. Use [TYPE] when assigning indirect device memory for macro programs.
D (Data area)
T (Timer relay area)
C (Counter relay area)
R (Accessory relay area)
X (Input channel)
Y (Output channel)
S (System relay area)
K (Thermal control relay area)
TSW (Timer setting area)
TP (Present timer setting area)
CSW (Counter setting area)
CP (Present counter setting area)
KJS (Thermal control temperature setting)
KP (Present thermal control temperature setting)
KJL (Thermal control low-temperature alarm setting)
KJH (Thermal control high-temperature alarm setting)
KI (Present thermal control current setting)
KJC (Insufficient thermal control)
KJR (Thermal control cycle setting)
*1 When using consecutive bit devices, select device memory "D" for improved performance.
Device Memory TYPE
00H
01H Read only
02H Read only
*1
03H
Common to D0 to D15
04H
Common to D16 to D30
05H
Common to D31 to D40
06H
Common to D41 to D55
07H
Common to D56 to D63
08H Common to D208 to D335
09H Read only, common to D336 to D463
0AH Common to D464 to D591
0BH Read only, common to D592 to D719
0CH Common to D80 to D95
0DH Read only, common to D96 to D111
0EH Common to D112 to D127
0FH Common to D128 to D143
10H Read only, common to D144 to D159
11H Common to D160 to D175
12H Common to D192 to D207
15.1 PLC Connection
Remarks
*1
*1
*1
*1
15-3