Hakko Electronics Monitouch V9 Series Connection Manual page 229

12-2 12. EMERSON
12.1.1 EC10/EC20/EC20H (MODBUS RTU)
Communication Setting
Editor
Communication setting
Item
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
PLC
Be sure to match the settings to those made under [Communication Setting] of the editor.
Calendar
This model is equipped with a calendar function; however, the calendar data cannot be written from the V series. Thus, time
correction must be performed on the controller side.
Available Device Memory
The available setting range of device memory varies depending on the PLC model. Be sure to set within the range available for
the PLC to be used. Use [TYPE] when assigning indirect device memory for macro programs.
D (Data register)
SD (Special data register)
Y (Output I/O)
X (Input I/O)
M (Auxiliary relay)
SM (Special auxiliary relay)
S (State relay)
T (Timer)
C (Counter)
Z (Offset addressing register)
TW (Timer)
CW (Counter)
CDW (Counter)
R (R)
Indirect Device Memory Designation
15
n+0 Model
n+1
n+2
Expansion code
n+3
* For bit designation, an expansion code setting is required.
00H: when designating bit 0 to 15
01H: when designating bit 16 to 31
1 : 1 / 1 : n / Multi-link2 / Multi-link2 (Ethernet) /
1 : n Multi-link2 (Ethernet)
RS-232C / RS-422/485
4800 / 9600 / 19200 / 38400 bps
Device Memory
8 7
Device type
Address No.
* Bit designation
00 Station number
Setting
8 bits
1 / 2 bits
Odd /Even / None
1 to 247
TYPE
00H
01H
02H
03H
04H
05H
06H
07H
08H
09H
0AH
0BH
0CH Double-word
0DH
0
(Underlined setting: default)
Remarks
Remarks