Hakko Electronics Monitouch V9 Series Connection Manual page 319

16-66 16. Fuji Electric
16.2.21 HFR-C11K
Communication Setting
Editor
Communication setting
Item
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
IH Inverter
Be sure to match the settings to those made under [Communication Setting] of the editor. (Underlined setting: default)
SW3 setting (station address / terminating resistance)
Switch
1
2
3
4
Station
Address
5
Terminating
6
Resistance
*1 For connection to a V9, be sure to set the station address other than 0.
Communication setting
Set communication parameters.
Be sure to match the settings to those made under [Communication Setting] of the editor.
Function Code
r 04
r 05
r 06
r 07
r 10
* RS-485 communication is available when the communication is enabled by digital input.
Example: To make the communication enabled when digital input terminal X1 is turned ON;
Set "11 (RS485 communication selection (RS))" for function code i01 and turn on the digital input terminal X1 externally.
Terminals from X2 to X5 can also be used. Set the function code corresponding to the digital input terminal to use.
1 : 1 / 1 : n / Multi-link2 /
Multi-link2 (Ethernet) /
1 : n Multi-link2 (Ethernet)
4800 / 9600 / 19200 bps
None / Odd / Even
Contents
Switch
1
Address
0 OFF OFF
1 ON OFF
2 OFF ON
3 ON ON
*1
: :
28 OFF OFF
29 ON OFF
30 OFF ON
31 ON ON
Contents
Terminating resistance
Item
Baud rate
Data length
Parity bit
Stop bit
*
Communication protocol
Setting
RS-422/485
7 / 8 bits
1 / 2 bits
1 to 31
2 3 4 5
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
: : : :
ON ON ON
ON ON ON
ON ON ON
ON ON ON
OFF ON
None Provided
2: 4800 bps
3: 9600 bps
4: 19200 bps
0: 8 bit
1: 7 bits
0: None
1: Even
2: Odd
0: 2 bit
1: 1 bits
0: FGI-bus
1: C9K mode
(Underlined setting: default)
Remarks
Example:
Station Address: 1
Terminating Resistance: None
(Underlined setting: default)
Setting Example
3
1
1
1
0