Hakko Electronics Monitouch V9 Series Connection Manual page 294

Address F-MPC04/F-MPC04P/F-MPC04S
85zz
86zz
87zz
88zz
89zz
90zz
91zz
92zz
*1 When using a direct value, set [DEC (with sign)] for [Display Format] on the [Num. Display] window.
*2 Specify "1" for [Decimal Point] on the [Num. Display] window.
*3 Specify "2" for [Decimal Point] on the [Num. Display] window.
*4 Specify the multiplying factor in the range of 3 to 2.
*5 Specify the pulse constant in the range of 2 to 4 or F.
Address denotations:
 For the device memory for which the circuit number is set (00 to 02, 12 to 18):
XXYYZZ
Circuit No. (1 to 12)
Setting item (00 to 99)
Device type
* For circuit No. E, specify "11" for the circuit number.
 For the device memory for which the circuit number is not set (03, 09 to 11):
XXYYYY
Setting item (00 to 99)
Device type
Note on Setting the Device Memory
Only the "List" file of "F-MPC04S" can be browsed by pressing the [Refer] button by default.
If any power monitor unit other than above is used, refer to each "List" file by pressing the [Refer] button and set the
device memory.
16.2 Temperature Controller/Servo/Inverter Connection
(Blank)
(Blank)
(Blank)
(Blank)
(Blank)
(Blank)
(Blank)
(Blank)
FePSU F-MPC30/F-MPC50/F-MPC55V/F-MPC60B
(Blank) Transducer output CH1 setting
(Blank) Transducer output CH2 setting
(Blank) Transducer output CH3 setting
(Blank) Transducer output CH4 setting
(Blank) Transducer output CH5 setting
(Blank) Transducer output CH6 setting
External change-over function setting of
(Blank)
transducer output
(Blank) Display mode selection
16-41