1 : N Multi-Link2 (Ethernet; Bits; None / Odd / Even 0 To; Pxg (Modbus Rtu) - Hakko Electronics Monitouch V9 Series Connection Manual

16.2.3 PXG (MODBUS RTU)

Communication Setting
Editor
Communication setting
Item
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
Temperature Controller
The communication parameter can be set using keys attached to the front of the temperature controller.
Be sure to match the settings to those made under [Communication Setting] of the editor.
Channel
Communication (Ch9)
* The communication function of the temperature controller can be selected at the time of purchase. Select a model on which RS-485
(Modbus) communication is available.
* The following communication parameters are fixed; data length: 8 bits and stop bit: 1 bit.
Available Device Memory
The available setting range of device memory varies depending on the model. Be sure to set within the range available for the
model to be used. Use [TYPE] when assigning indirect device memory for macro programs.
Device Memory
1 (input relay)
4 (holding register)
3 (input register)
16.2 Temperature Controller/Servo/Inverter Connection
Setting
1 : 1 / 1 : n / Multi-link2 /
Multi-link2 (Ethernet) /
1 : n Multi-link2 (Ethernet)
RS-422/485
9600 / 19200 bps

8 bits

1 bit
None / Even / Odd
1 to 31
Parameter Display
STno Station number
CoM Parity
SCC Communication authority
TYPE
01H
02H
03H
Do not change the default settings of the signal level, data
length and stop bit because these settings on the temperature
controller cannot be changed.
Item
1 to 31
96od (9600 bps / odd parity)
96Ev (9600 bps / even parity)
96no (9600 bps / without parity)
19od (19200 bps / odd parity)
19Ev (19200 bps / even parity)
196no (19200 bps / without
parity)
r (Read only)
rW (Read/write allowed)
Remarks
16-27
(Underlined setting: default)
Remarks
(Underlined setting: default)
Setting Example
1
96od
rW