Hakko Electronics Monitouch V9 Series Connection Manual page 123

PORT2
Set parameters into the special register "R774, 775", then set "A5AA" (HEX) into the setting complete register "R767". When
the set value at R767 is changed to "AAAA" (HEX), it is regarded as normal; if it is changed to "AEAA" (HEX), it is regarded as
erroneous.
Parameter setting register
Register
R774 Same as the setting register R772 for PORT1
R775 Same as the setting register R773 for PORT1
PORT3
Set parameters into the special register "R776, 777", then set "5AAA" (HEX) into the setting complete register "R767". When
the set value at R767 is changed to "AAAA" (HEX), it is regarded as normal; if it is changed to "EAAA" (HEX), it is regarded as
erroneous.
Parameter setting register
Register
R776 Same as the setting register R772 for PORT1
R777 Same as the setting register R773 for PORT1
D2-240/D2-250-1
PORT1 / PORT2
No particular setting is necessary on the PLC. The PLC performs communication functions using the following parameters. Set
the following parameters under [Communication Setting] of V9.
Baud Rate
Parity
Data Length
Stop Bit
Data Type
Available Device Memory
The available setting range of device memory varies depending on the PLC model. Be sure to set within the range available for
the PLC to be used. Use [TYPE] when assigning indirect device memory for macro programs.
V (data register)
X (input)
Y (output)
C (internal relay)
S (stage)
GX (transmission relay for all stations)
GY (transmission relay for specified station)
T (timer/contact)
CT (counter/contact)
Item
Device Memory
Setting
Setting
Setting
For PORT2:
9600 bps
19200 bps can be set in the special register.
Odd
8
1
HEX
TYPE
00H
01H
02H
03H
04H
05H
06H
07H
08H
3.1 PLC Connection
Setting Example
00E0H
8701H
Setting Example
00E0H
8701H
Remarks
Remarks
3-3