Hakko Electronics Monitouch V9 Series Connection Manual page 144

4.2.8 DMC10
Communication Setting
Editor
Communication setting
Connection Mode
Signal Level
Baud Rate
Data Length
Stop Bit
Parity
Target Port No.
Controller
Rotary switch for device address
MODULE ADDRESS
CPL communication setting
Make the following settings on the PC loader. (Underlined setting: default)
Setting Items
CPL/MODBUS
Baud rate
Data type
Available Device Memory
The available setting range of device memory varies depending on the controller model. Be sure to set within the range
available for the controller to be used. Use [TYPE] when assigning indirect device memory for macro programs.
Device Memory
* The number of times EEPROM can be reprogrammed is limited (approx. 100,000 times). Accordingly, we recommend that
you write such a parameter as to be reprogrammed frequently into RAM, where the number of reprogramming times is
not limited. However, when the parameter has been written into RAM, and the power is turned off and back on again,
data in EEPROM is transferred.
For more information, refer to the instruction manual for the controller issued by the manufacturer.
Item
1 : 1 / 1 : n / Multi-link2 / Multi-link2 (Ethernet) /
C
1 to F
0: CPL
1: 4800 bps
2: 9600 bps
3: 19200 bps
0: 8 bits / 1 bit / even
1: 8 bits / 2 bits / none
TYPE
--- 00H
4.2 Temperature Controller/Servo/Inverter Connection
Setting
1 : n Multi-link2 (Ethernet)
RS-232C / RS-422/485
4800 / 9600 / 19200 bps
7 / 8 bits
1 / 2 bits
None / Odd / Even
1 to 31
Setting
Setting
Without "*": RAM
With "*": RAM + EEPROM
(Underlined setting: default)
Remarks
Remarks
Communication is disabled when "0" is set.
Remarks
See "20. MODBUS".
Remarks
4-13