Micrex-Sx Model Selection - Hakko Electronics Monitouch V9 Series Connection Manual

MICREX-SX Model Selection

When the MICREX-SX SPH or SPB series is connected, a mode selection may be required on the V9 editor depending on the
programming tool used on the PLC or the setting on the programming tool.
PLC
SX-Programmer Expert (D300win)
SX-Programmer
SPH series Standard (Ver. 1 / 2)
SX-Programmer
Standard (Ver. 3)
SX-Programmer Expert (D300win)
SX-Programmer
Standard (Ver. 1 / 2)
SX-Programmer
SPF series
Standard (Ver. 3)
SX-Programmer
Standard (Ver. 1 / 2)
FLEX-PC Programmer
*1 The setting procedure differs depending on the version of the SX-Programmer Standard tool.
- Ver. 1 or 2:
Check or uncheck the box for [Express address in MICREX-F address type] on the [Editor Options] tab window in the [Environment
Options for MICREX-SX] dialog ([Options]  [MICREX-SX Environment]).
- Ver. 3:
Select "MICREX-F" from [Address display mode] ([Tool] [Options]  [Category: General]).
*2 [Mode Select] dialog on the V9 editor
PLC Programming Tool
Address Expression
Unchecked
Checked
FLEX-PC
MICREX-F
Unchecked
SX-MODE
Checked
FLEX-PC
MICREX-F
N-MODE -
-
- [IEC Mode]: Variable name cooperation function
- [N Mode]:
- [F Mode]:
* Except bit addresses
16.1 PLC Connection
Setting on the V9 Editor
PLC Selection
*1
MICREX-SX SPH/SPB series
MICREX-SX SPH / SPB CPU
*1
MICREX-SX (Ethernet)
*1
*1
*1
MICREX-SX SPH/SPB series
*1
MICREX-SX SPH / SPB CPU
*1
*1
SPB (N mode) & FLEX-PC series
SPB (N mode) & FLEX-PC CPU
Address denotation "hexadecimal"
Address denotation "decimal"
16-3
Mode
Selection
IEC Mode
N Mode
F Mode
N Mode
F Mode
IEC Mode
N Mode
F Mode
N Mode
F Mode
-
-
*
*
*2