Hakko Electronics Monitouch V9 Series Connection Manual page 264

NW0LA-RS2, NW0LA-RS4 (parameter setting)
On the PLC loader, set parameters for general communications.
Be sure to match the settings to those made under [Communication Setting] of the editor.
Item
Mode
Baud rate
Parity
Data bits
Stop bits
Available Device Memory
Variable name cooperation function
The variable name cooperation function can be used only for PLC1. For device memory assignment, basically use the
variable name cooperation function. It is recommended that you specify a device memory address in the [AT] field
to define the area (variable) that is used for communications with the V9.
The available setting range of device memory varies depending on the PLC model. Be sure to set within the range available for
the PLC to be used. Use [TYPE] when assigning indirect device memory for macro programs.
Device Memory
%IX (input memory)
%QX (output memory)
%MX1. (standard memory)
%MX3. (retain memory)
%MX10. (system memory)
*1 For the input/output memory, the variable name cooperation function of the PLC1 must be used. Indirect designation is not available
with the input/output memory.
*2 Double-word addresses (%MD1., %MD3., %MD10.) can be specified only for PLC1.
In the case with PLC2 to PLC8, access to the above addresses is possible when the data length is set to 2 words in the word address
(%MW1., %MW3., %MW10.).
Example: When accessing the address in %MD1.100:
Set the data length to 2 words for %MW1.100.
*3 The assigned device memory is expressed as shown below when editing the screen.
- For %IX or %QX:
- For %MX1., %MX3., or %MX10:
Setting
Loader
4800 / 9600 / 19200 / 38400
Odd / Even / None
8
1 / 2
TYPE
*1
-
%IW as word device, %ID as double-word device
*1
-
%QW as word device, %QD as double-word device
02H
%MW1. as word device, %MD1. as double-word device
04H
%MW3. as word device, %%MD3. as double-word device
08H
%MW10. as word device, %MD10. as double-word device
16.1 PLC Connection
Remarks
Example: %IX1 . 1 . 0
Bit address (DEC)
Period
Word address
Period
SX station number
Example: %MX1 . 1 . 1 . 0
Bit address (DEC)
Period
Word address
Period
CPU No.
16-11
Remarks
*3
*3
*2 *3
*2 *3
*2 *3