Hakko Electronics Monitouch V9 Series Connection Manual page 372

PAC Systems
Parameter
Port Mode
Data Rate
Parity
Stop Bits
Physical Interface
VersaMax / VersaMax Micro & Nano / IC200USB001 / IC200USB002
Parameter
Port Mode
Port Type
Data Rate
Parity
Stop Bits
Physical Interface
Calendar
This model is not equipped with the calendar function. Use the built-in clock of the V series.
Available Device Memory
The available setting range of device memory varies depending on the PLC model. Be sure to set within the range available for
the PLC to be used. Use [TYPE] when assigning indirect device memory for macro programs.
R (register)
I (input)
Q (output)
M (internal relay)
G (global relay)
AI (analog input)
AQ (analog output)
T (temporary memory relay)
S (system status)
SA (system status)
SB (system status)
SC (system status)
P (local subblock data)
L (program block data)
Indirect Device Memory Designation
For the device memory address number, specify the value obtained by subtracting "1" from the actual address.
4800 / 9600 / 19200 / 38400 / 57600 / 115200 bps
4800 / 9600 / 19200 / 38400 bps
ODD / EVEN / NONE
Device Memory
Setting
SNP Slave
ODD / EVEN / NONE
1
2-wire / 4-wire
Setting
SNP
Slave
1 / 2
2-wire / 4-wire
TYPE
00H
01H
02H
03H
04H
05H
06H
07H
08H Read only
09H
0AH
0BH
0CH 90-70 series only
0DH 90-70 series only
18.1 PLC Connection
(Underlined setting: default)
Remarks
Both valid for RS232
(Underlined setting: default)
Remarks
Both valid for RS232
Remarks
18-7