Nx (Modbus Tcp/Ip) - Hakko Electronics Monitouch V9 Series Connection Manual

4.2.15 NX (MODBUS TCP/IP)

Communication Setting
Editor
Make the following settings on the editor. For more information, see "1.3.2 Ethernet Communication".
 IP address for the V9 unit
- When specified on the screen program:
[System Setting]  [Hardware Setting]  [Local Port IP Address]
- When specified on the V9 unit:
Local mode  [LAN Setting]
 Port number for the V9 unit (for communication with PLC)
[System Setting]  [Hardware Setting]  [PLC Properties]  [Communication Setting]
 IP address, port number, and maximum read value of the PLC
Register on the [PLC Table] in [System Setting]  [Hardware Setting]  [PLC Properties]  [Target Settings].
Controller
Make the following settings on [Actual Module Configuration] in the [SLP-NX] software.
IP Address
IP Setting
Port Setting
4.2 Temperature Controller/Servo/Inverter Connection
Item
-
Net mask
Default gateway
MODBUS communication port number
Valid only for 1 : 1 connection
Select the PLC for connection from those
registered on the PLC table.
Set the IP address, port number, maximum
read value, and whether or not to use the
KeepAlive function of the controller.
Maximum read value:
Set a value according to the controller
specification.
32 or 64 words
Remarks
Default: 502
4-27