Hidic-S10V (Ethernet) - Hakko Electronics Monitouch V9 Series Connection Manual

19.1.5 HIDIC-S10V (Ethernet)

Communication Setting
Editor
Make the following settings on the editor. For more information, see "1.3.2 Ethernet Communication".
 IP address for the V9 unit
- When specified on the screen program:
[System Setting]  [Hardware Setting]  [Local Port IP Address]
- When specified on the V9 unit:
Local mode  [LAN Setting]
 Port number for the V9 unit (for communication with PLC)
[System Setting]  [Hardware Setting]  [PLC Properties]  [Communication Setting]
 IP address and port number of the PLC
Register on the [PLC Table] in [System Setting]  [Hardware Setting]  [PLC Properties]  [Target Settings].
PLC
LQE520
Module No. setting switch
MODU NO
0
2
S10V ET.NET
Specify the IP address and the subnet mask.
LQP520
Station No. setting switch
S/T NO
U L
Standard system tool
Specify the IP address and the subnet mask.
Contents
Communication via 10BASE-5
Communication via 10BASE-T
Setting
0 0 Set IP address is valid.
F F 192.192.192.1 is valid.
19.1 PLC Connection
Remarks
Contents
19-9