Countershaft Sprocket; Alternator And Starter Assembly - Honda CB350 Repair Manual

ENGINE AND TRANSMISSION 74
COUNTERSHAFT SPROCKET
1. Remove the left rear
cover as described previously.
2. To remove the sprocket, remove the
two bolts from the sprocket and rotate the
lockplate until the tabs on the plate line
up with the slots in the countershaft. Re—
move the lockplate.
crankcase
Removing the sprocket lockplate
3. Either move the rear wheel forward
in the swing arm or remove the mas—
terlink from the chain, and pull the
sprocket off the countershaft.
4. When refitting the sprocket, install
the sprocket on the countershaft. If the
masterlink has not been removed, refit
the chain to the sprocket before installing
the sprocket to the countershaft. Install
the lockplate on the countershaft and ro—
tate it until the holes in the sprocket line
up with the holes in the lockplate. Install
the two bolts and torque to 5.8—8.7 ft lbs.
ALTERNATOR AND STARTER
ASSEMBLY
Removal
1. Remove the crankcase covers and
stator as described previously.
2. Remove the rotor bolt while holding
the engine from turning over.
3. Remove the alternator rotor using
the factory rotor puller. In most cases the
rear axle can be used in place of the pul—
ler; screwthe axle into the center ofthe