Replacing The Cr Actuator Pulley And The Cr Deceleration Belt - MUTOH Rockhopper II series Maintenance Manual

4.6.6. Replacing the CR actuator pulley and the CR deceleration belt

Notes :
Step 1 :
Follow the instructions in "Replacing the CR motor assembly" to remove the CR motor assembly.
Step 2 :
Follow the instructions in "Replacing the steel belt" to remove the steel belt.
Step 3 :
Replace the CR actuator pulley.
Step 4 :
Replace the CR deceleration belt.
1 = CR slave pulley
Step 5 :
Reinstall all parts in the opposite order of the removal procedure.
Step 6 :
Adjust the tension of the CR deceleration belt according to "CR deceleration belt tension
adjustment".
Notes :
Remove following covers before replacing the CR slave pulley.
Side cover R: refer to "Removing side cover R"
Side cover L: refer to "Removing side cover L"
Front cover: refer to "Removing the front cover"
Carriage cover: refer to "Removing the carriage cover"
Y rail cover: refer to "Removing the Y rail cover"
After installing the CR actuator pulley assembly, move the carriage to the left and
right manually to confirm that the steel belt has been set equally in the center of the
CR actuator pulley and the CR slave pulley assembly.
Rockhopper II series printers – Maintenance Manual
2 = CR deceleration belt
92 AP-74065, Rev. 1.2, 27/09/04