Neutral Diode - Honda XR125LK Owner's Manual

dummyhead dummyhead
ELECTRIC STARTER
FUNCTION INSPECTION
Remove the starter relay switch (page 5-7).
Connect an ohmmeter [1] to the starter relay switch [2]
cable terminals.
Connect the fully charged 12 V battery [3] to the relay
switch connector terminals.
CONNECTIONS: Battery (+) terminal – Yellow/red
There should be continuity between the cable terminals
while the battery is connected, and no continuity when
the battery is disconnected.
Install the starter relay switch (page 5-7).

NEUTRAL DIODE

INSPECTION
Remove the rear cowl (page 2-3).
Remove the neutral diode [1] from the connector boot.
EXCEPT NZ TYPE:
Check for continuity between the diode terminals.
When there is continuity, a small resistance value will
register.
If there is continuity in one direction, the neutral diode is
normal.
Install the neutral diode in the reverse order of removal.
NZ TYPE:
Check for continuity between the diode terminals.
When there is continuity, a small resistance value will
register.
If there is continuity in one direction, the neutral diode is
normal.
Install the neutral diode in the reverse order of removal.
5-8
Battery (–) terminal – Green/red
[1]
[1]
EXCEPT NZ TYPE:
A
A
B
NZ TYPE:
B
A
A
C
[3]
[2]
B
B
C