Inspection And Repair - Isuzu 1999 RODEO Workshop Manual

1A–68 HEATING, VENTILATION AND AIR CONDITIONING (HVAC)
3. Remove shim (s).
4. Remove snap ring (1) by using snap ring pliers.
5. Remove pulley assembly by using pulley puller pilot
J-38424, pulley puller J-8433 and pulley puller leg
J-24092-2.
6. Loosen screw and disconnect the coil lead wire
connector.
871RW016
7. Loosen three screws and remove the field coil.

Inspection and Repair

871RS009
Drive Plate
If the frictional surface shows signs of damage due to
excessive heat, the drive plate and pulley should be
replaced.
Pulley Assembly
Check the appearance of the pulley assembly. If the
frictional surface of the pulley shows signs of excessive
grooving due to slippage, both the pulley and drive plate
should be replaced. The frictional surfaces of the pulley
assembly should be cleaned with a suitable solvent
before reinstallation.
Coil
Check coil for loose connector or cracked insulation.
871RS010
871RS011