Removal; Installation; Blower Assembly 1A-18; Blower Assembly And Associated Parts - Isuzu 1999 RODEO Workshop Manual

1A–18 HEATING, VENTILATION AND AIR CONDITIONING (HVAC)

Installation

To install, follow the removal steps in the reverse order,
noting the following points:

Blower Assembly and Associated Parts

Legend
(1) Instrument Panel Assembly
(2) Blower Assembly

Removal

1. Disconnect the battery ground cable.
2. Discharge and recover
conditioning).
f Refer to Refrigerant Recovery in this section.
Blower Assembly
refrigerant (with air
1. Apply grease to the sub-lever and to the abrasive
surface of the heater unit.
2. After installing the link unit, check to see if the link unit
operates correctly.
(3) Evaporator Assembly (A/C only)
(4) Duct
(5) Heater Unit
3. Remove instrument panel assembly.
f Refer to Instrument Panel Assembly in Body and
Accessories section.
4. Disconnect resistor connector.
5. Remove duct.
873RW004