5C–12 POWER–ASSISTED BRAKE SYSTEM
Front
Caliper
Associated Parts
Legend
(1) Bolt and Gasket
(2) Clip
(3) Hose
(4) Brake Pipe
Front Caliper Brake Hose
Brake
Hose
and
352RW001
Removal
1. Raise the vehicle and support it with suitable safety
stands.
2. Remove the wheel and tire assembly.
3. Clean dirt, grease, and other foreign material off the
hose fittings at both ends.
4. Disconnect brake pipe.
5. Remove clip.
6. Remove bolt and gasket.
7. Remove hose.
Installation
To install, follow the removal steps in the reverse order,
noting the following points.
1. Tighten the brake pipes to the specified torque
Torque: 16 N·m (12 lb ft)
2. Tighten the bolt to the specified torque.
Torque: 35 N·m (26 lb ft)
NOTE: Always use new gaskets and be sure to put the
hooked edge of the flexible hose end into the anti–rotation
cavity.
After installing the brake hoses, bleed the brakes as
described in this section.