1A–14 HEATING, VENTILATION AND AIR CONDITIONING (HVAC)
Installation
To install, follow the removal steps in the reverse order,
noting the following points:
1. When handling the PCM and the control unit, be
careful not to make any improper connection of the
connectors.
Disassembled View
Legend
(1) Heater Core
(2) Case (Temperature Control)
(3) Heater Unit
Removal
1. Disconnect the battery ground cable.
2. Drain the engine coolant.
Heater Core and / or Mode Door
2. Adjust the control cables.
f Refer to Control Lever Assembly in this section.
3. When installing the heater unit, defroster nozzle and
center vent duct, be sure that the proper seal is made,
without any gap between them.
(4) Mode Door
(5) Duct
(6) Case (Mode Control)
3. Discharge
and
recover
conditioning).
f Refer to Refrigerant Recovery in this section.
860RW001
refrigerant
(with
air