Inspection And Repair; Reassembly - Isuzu 1999 RODEO Workshop Manual

2. Remove the rear output shaft assembly (1) from the
transfer rear cover (with oil seal) (9).
3. Remove ball bearing (8), using a bench press and the
bearing remover J–22912–01.
4. Remove speedometer drive gear (7).
5. Remove ball (6).
6. Remove bearing snap ring (5), using a pair of snap
ring pliers.
7. Remove rear output shaft (2) from the ball bearing (4),
using a bench press and the bearing remover
J–22912–01.

Inspection and Repair

Refer to "TRANSFER CASE ASSEMBLY" in this section
for inspection and repair.

Reassembly

Transfer rear cover (with oil seal) (9). Oil seal
replacement.
f Remove the oil seal from the transfer rear cover.
f Apply engine oil to the oil seal outer surfaces.
f Fill in recommended grease (BESCO L2) or
equivalent in the oil seal lip.
f Use the oil seal installer J–39208 to install the rear oil
seal to the transfer rear cover.
226RS061
1. Install ball bearing (4) to the rear output shaft (2),
using the ball bearing installer J–37223 and the
adapter J–37486–A.
226RS062
TRANSFER CASE 4D–17
220RS019
262RW021