4D–8
TRANSFER CASE
7. Raise and support vehicle with suitable stands. Drain
transfer case fluid.
8. Remove transfer protector (6) and fairing plate (7).
9. Remove rear propeller shaft (8) and front propeller
shaft (9).
NOTE: Apply alignment marks on the flange at both front
and rear sides.
10. Disconnect harness connectors and clip.
Connector: transfer switch, 2WD–4WD actuator,
speed sensor.
11. Support transmission case with a transmission jack.
12. Remove the top position bolt from transfer control
lever hole and others under the floor.
Remove transfer case (10) from the vehicle.
Installation
1. Apply a thin coat of molybdenum disulfide grease to
the input shaft spline as shown in the figure.
150RW006
260RW001