Universal Joint Reassembly - Isuzu 1999 RODEO Workshop Manual

4C–44
DRIVE SHAFT SYSTEM
f Aluminum tube type only: Inspect the aluminum
tubing for surface scratches and dents.
scratches may not exceed 0.2 mm (0.008 in) in depth.
f Aluminum tube type only: Visually inspect the circle
welds and fittings for any signs of cracks or signs of
deterioration. If there are any cracks that exceed 0.2
mm (0.008 in) in depth, the assembly must be
replaced.
f Aluminum tube type only: Check to be sure there are
no missing balance weights. If balance weights are
missing and void has occurred in the aluminum tubing
greater than 0.2 mm (0.008 in), the assembly must be
replaced.

Universal Joint Reassembly

These
1. Pack the four grease cavities of the spider with a high
quality, extreme pressure N.L.G.I. Grade 2 grease.
Do not add additional grease to bearing cup
assembly.
2. Move one end of the spider to cause a trunnion to
project through the spider hole beyond the outer
machined face of the yoke lug. Place a bearing over
the trunnion diameter and align it to the spider hole.
Using an arbor press, hold the trunnion in alignment
with the spider hole and place a solid plug on the
upper bearing. Press the bearing into the spider hole
enough to install snap ring.
401RW022
3. Install a snap ring.
NOTE: Be sure the snap rings are properly seated in the
grooves.
4. Repeat steps 2 and 3 to install the opposite bearing. If
the joint is stiff, strike the yoke ears with a soft
hammer to seat the bearing.
5. Align the setting marks and join the yokes.
401RW026