4C–24
DRIVE SHAFT SYSTEM
Reassembly
1. Install the new oil seal which has been immersed in
differential gear oil, by using an oil seal installer
J–41693 and grip J–8092.
2. Force a new needle bearing into inner shaft by using a
Installer J–41694 and grip J–8092.
412RS037
3. Place a new snap ring(internal) in inner shaft.
Force a new inner shaft bearing into the inner shaft.
4. Install snap ring(external).
412RW034
NOTE: Be careful not to damage the inner shaft.
5. Clean the housing contact surface of the front axle
case and insert inner shaft assembly into the front
axle case.
NOTE: Be careful not to damage seal.
6. Install snap ring internal in the groove of front axle
case.
NOTE: Be sure to install the snap ring properly.
412RS051
412RS044