Inspection And Repair; Installation - Isuzu 1999 RODEO Workshop Manual

4. Remove flange nut and washer by using pinion flange
holder J–8614–01 after raising up its staked parts
completely.
5. Remove flange by using SST J–8614–1 ∼ 3.
f Have a suitable container in place to catch
lubricant.
6. Remove oil seal.
7. Remove pinion oil seal slinger.
8. Remove outer bearing by using remover J–39602.
425RW037
9. Remove collapsible spacer.

Inspection and Repair

Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal condition are
found through inspection.
Check the following parts.
1. Seal surface of the flange.
2. Cage bore for burns.

Installation

1. Install collapsible spacer, discard the used collapsible
spacer and install a new one.
2. Install outer bearing.
425RW038
DIFFERENTIAL (REAR) 4A2–11
425RS090