Installation - Isuzu 1999 RODEO Workshop Manual

f Install the rubber bushing by using installer
J–39214.
NOTE: When mounting rubber bushings, be sure not to
use grease on bushings or any other nearby part.

Installation

1. Install trailing link. Make sure that the trailing link is in
its correct position.
NOTE: When mounting trailing link, be sure not to use
grease on bushings or any other nearby part.
2. Install bolt, nut and protector. Tighten the bolts and
nuts lightly, then retighten them to the specified
torque after the vehicle is at curb height.
Torque: 137 N·m (101 lb ft)
3. Install parking brake cable.
CAUTION: The parking brake cable should not be
overstrained or slackened.
901RW059
460RW011
REAR SUSPENSION 3D–9