3C–14 FRONT SUSPENSION
CAUTION: Be careful not to damage the ball joint
boot.
7. Remove upper ball joint.
8. Remove bolt and plate.
9. Remove nut assembly.
10. Remove camber shims and note the positions and
number of shims.
11. Remove caster shims and note the positions and
number of shims.
12. Remove upper control arm assembly.
13. Remove nut.
14. Remove plate.
15. Remove bushing by using remover J–29755.
16. Remove fulcrum pin.
901RW162
Inspection and Repair
Make necessary parts replacement if wear, damage,
corrosion or any other abnormal conditions are found
through inspection.
Check the following parts:
f Upper control arm
f Bushing
f Fulcrum pin
Installation
1. Install fulcrum pin.
2. Install bushing by using installer J–29755 and
J–39376.
901RW161
901RW160
901RW164