Power Meter Configuration Changes
The Agilent EPM Series, EPM- P Series, or P- Series power meters recognize
the Agilent N8480 Series power sensor when it is connected. The N8480
Series power sensors (excluding Option CFT) calibration data is
automatically read by the power meter. In addition, the auto- averaging
settings shown in
N8481/2/5/7/8A
N8486AQ/AR
–10 dBm
–20 dBm
–30 dBm
Figure 1-8 Auto-averaging settings
These values are valid only for the power meter channel connected to an Agilent N8480
N O T E
Series power sensor. Averaging settings can also be manually configured. Refer to the
respective power meter's User's Guide for information on setting the averaging (filtering).
N8480 Series Power Sensors Operating and Service Guide
Figure 1- 8
N8481/2B
0 dBm
30 dBm
–1 dBm
29 dBm
20 dBm
10 dBm
0 dBm
are also automatically configured.
Maximum
N8481/2H
Sensor Power
20 dBm
17 dBm
10 dBm
0 dBm
–10 dBm
Minimum
Sensor Power
Introduction
Resolution Setting
1
2
3
4
1
1
2
8
2
2
4
32
2
2
4
32
2
2
16
256
2
8
128
128
4
64
256
512
1
17